Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Jacobs rods resist grooving much better than the other brands I have used in the past.”
“Jacobs Hammers are amazing, can hardly see any wear on them!”
“Dale said the Lightning Die he has on mill #2 has 600 hours on it and is still the best running mill!”
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“It will be Jacobs from here on out! The guys said Jacobs Pentagons were by far the easiest to install and they really enjoy using them versus the others.”
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”
“The Lightning resulted in 48% decrease in energy with 19% increase in throughput. Savings $32K!”
“Very Happy with the Lightning Die and don’t want to change a thing!”
“The Triple Threats are living up to the talk on our Bliss Mill. [Competitor] hammers are needing replaced and Jacobs’ barely looked used!”